Short answer: yes, in most cases you can fit shower wall panels over existing tiles. It is one of the main reasons people choose panels. You avoid the dust, the skip and the days spent chipping tiles off the wall.
Check your tiles first
- Are they firmly stuck? Tap each tile. A hollow sound means it is loose. Remove loose tiles and fill the gap flush.
- Is the wall flat? Hold a long straight edge against the wall. Panels need a flat surface, so pack out or remove anything that bulges.
- Is it clean and dry? Clean off soap, grease and mould, and let the wall dry fully before gluing.
- Is the wall itself sound? If water has already got behind the old tiles and the wall is soft or damp, fix that first. Panels should never be used to hide a leak.
Fitting panels over tiles, step by step
- Plan the layout. Our Rapid Stoneβ’ panels are 600mm wide and 2440mm tall, so measure each wall and work out where the joins will fall.
- Fit the trims. Corner and end trims go on as you work. Internal corner trims go into the corners, and end trims finish open edges.
- Cut to size. Cut panels to height and width, and cut holes for the shower valve or pipes. Ask us which blade to use if you are unsure.
- Glue. Apply panel adhesive to the back of the panel and press it firmly onto the tiles.
- Join. Fit the next panel into the joint. Rapid Tileβ’ HydroClickβ’ edges angle in and click shut; Rapid Stoneβ’ panels slide together tongue-and-groove.
- Seal. Run a sanitary silicone along every joint, trim and the base of the panels.
Waterproofing: what you need to know
Rapid Stoneβ’ and Rapid Tileβ’ panels are fully waterproof, but they are one part of your shower wall, not a complete waterproofing system. Around baths and splashbacks, sealing every joint, trim and cut-out with silicone is enough. Inside showers and wet rooms we recommend tanking the wall first with a shower waterproofing kit, as you would before tiling. Installation is the responsibility of the customer or installer.
What about the extra thickness?
Fitting over tiles adds the panel thickness to the wall. Around the shower valve and any fittings, you may need extension pieces so the fittings sit flush. A plumber can advise if you are not sure.
Which panels work over tiles?
- Rapid Stoneβ’ stone and marble effect panels, a solid 8mm stone-based board.
- Rapid Tileβ’ tile effect panels, the tiled look without the grout.
We deliver from Dungannon, Co. Tyrone across Northern Ireland and Ireland. Rapid Tileβ’ can also be delivered to England, Scotland and Wales. Order free samples to see the finishes at home.


